The polygon pour will connect to each pad and via on this net that is found within the outline of the polygon, in accordance with the applicable Polygon Connect Style design rule.

.

Additionally, on the Int2 layer, create a polygon for the VCC_3. The polygon net is set to the same net name.

Notice how the.

We suggest the following naming of the polygons: GND_Int1, GND_Int2, GND_Bottom.

I would not agree to create any rule for allowing short circuits, this is a gateway for evil. com%2fdocumentation%2faltium-designer%2fpcb-polygon-pour%3fversion%3d18. Figure 14: Extreme example of what can be achieved with Net Tie footprints.

Pour Over Same Net Polygons Only - pour the polygon in free space and also pour over existing polygons that belong to the same net.

All fanout vias and connecting track will be placed outside of the. . .

. Altium distinguishes polygon pours from plane layers.

There are two ways to solve this situation.

Posts: 328.

. Note that they can also be solid by setting the Track Width to be larger than the Grid Size.

Mar 28, 2011 · I'm designing a board in Altium which uses a 0. Select the required net in the Connect to Net drop-down in the Properties panel.

Create Solid Polygons - enable this option to ensure polygons (copper pours) are created when exporting CAM Editor designs.

MrBit Asks: Altium Designer: Polygon does not connect to the pads on the same Net I'm trying to put a plane shield using polygon pour and I realized that some object is not connected to my polygon. Click on the Solid Polygon Options button for additional settings. SOLVED: I restarted Altium Designer and everything is fine now.

. Create Solid Polygons - enable this option to ensure polygons (copper pours) are created when exporting CAM Editor designs. Hatched Polygon Options - click to set up the hatched polygon such as the grid size, track width, minimum primitive length, and removing. . The following constraints apply only when using the Relief Connect style: Conductors - the.

As well as helping identify each polygon, the name can be used to target a specific polygon (or family of.

Note that the. .

.

0.

All fanout vias and connecting track will be placed outside of the.

Thanks! tuncsahin • 4 yr.

Polygons are positive features on positive (signal) layers, that fill large (or small) areas.